Arturia Forums
Hardware Sequencers => BeatStep => BeatStep - Technical Questions - FAQ => Topic started by: johnnygeldhof@telenet.be on June 22, 2014, 08:39:43 pm
-
Hi all,
I've got some problems with my Arturia Beatstep. I have updated the firmware perfectly, and synced with my device. When i press a button on my device, i can see
the button pressed-in on the arturia computer program.
The only problem is that i have no sound at all.
What could be the problem?
Thanks
-
I presume you have your Beatstep connected via midi or usb to a synthersiser or DAw vst?
or maybe you think the Beatstep has its own built in sounds ?
or this is a wind up?
-
I've got it connected with USB. I can plan with it on any program and get sound.
But when i want to use MIDI controle center, it can read all the button's been pressed it, but i cannot get any sound out of it.
Is this the main program from arturia or not? Or what should i do?
Thanks!
-
Hi
You use the MMC software just to configure the beat step
For example to change the midi note of a pad or to set the global midi channel
and then you save your config to a memory and then sync
you don't hear any sounds while your are setting up the beat step
I think your a bit confused
cheers
kev
-
So you are telling me that i should not use MIDI Controle Center to play with the beatstep?
-
Yes I am telling you that the CONTROL software is ONLY to SETUP the beatstep
NOT to play it
This has got to be a wind up
-
I'm sorry, i really didn't had a clue. I'll play it with the Arturia software
-
Was going to ask a question as a newbie, but seeing the responses from turb_kev it's obviously not a safe place for newbies!