Arturia Forums

Hardware Sequencers => BeatStep => General Discussion on BeatStep => Topic started by: jimmyjim on April 08, 2014, 09:31:25 am

Title: ext. sync with ableton live 9
Post by: jimmyjim on April 08, 2014, 09:31:25 am
Does anybody also have problems running the step sequencer in sync with ableton live 9?
When I stop the sequencer and click the ableton stop button to reset the play marker to the start of the song and press play again, it always is out of sync with a different offset.
Title: Re: ext. sync with ableton live 9
Post by: Terrym on April 08, 2014, 12:15:17 pm
hi .i have tested beatstep on live9.1 and its syncs ok ,make sure your marker is set to the start of a bar  as when you press stop beatstep will start where the marker is and if its set off beat it will start there and sound out of sync.

regards

terrym
Title: Re: ext. sync with ableton live 9
Post by: miguelmarcos on April 08, 2014, 10:34:10 pm
I've used it in Live 9 and the sync works fine.
Title: Re: ext. sync with ableton live 9
Post by: jimmyjim on April 09, 2014, 10:26:59 am
I changed the sync mode from song to pattern and now it runs better, I had to adjust the midi predelay to -26ms.
Title: Re: ext. sync with ableton live 9
Post by: Niph on April 26, 2014, 11:21:15 pm
Where exactly do I change this? The sync is abysmal on my PC, I am currently using the Beatstep only as a Pad/Knob Midi-Controller because the delay is all over the place.
Title: Re: ext. sync with ableton live 9
Post by: elastic on June 24, 2014, 03:58:30 pm
i would like to know too, where do you change the sync mode from song to pattern?