Arturia Forums

Hardware Sequencers => BeatStep => General Discussion on BeatStep => Topic started by: moonra on April 05, 2014, 10:59:42 am

Title: Beatstep & Microbrute : CV/Gate
Post by: moonra on April 05, 2014, 10:59:42 am

Hi all,

Ok this may seem pretty basic but hey, forgive me, I'm here to learn.

How do I hook up my Beatstep to my Microbrute if I only want to use CV and Gate cables (it works fine with midi).
Beatstep Gate out obviously goes to Microbrute Gate In. But what about Beatstep CV out ? Where should i plug it to make it control the pitch of the Microbrute ? Is there anything to set up in the Microbrute connection software ?

Forgive my noobness !

Thank you !

Title: Re: Beatstep & Microbrute : CV/Gate
Post by: KRS on April 05, 2014, 02:31:18 pm

You got to connect the Beatsteps CV out to the Microbrute pitch input. The pitch input is part of the mod-matrix!

Chris

Title: Re: Beatstep & Microbrute : CV/Gate
Post by: moonra on April 05, 2014, 02:33:48 pm

Just under my nose :)
Many thanks Chris!