Arturia Forums

Harware Legacy versions => Origin => Origin Technical Issues => Topic started by: ASch on July 17, 2012, 10:58:30 pm

Title: Sequencer Loop Behaviour
Post by: ASch on July 17, 2012, 10:58:30 pm

Just noticed... when I run the sequencer with a loop and then turn the loop off, the sequencer does not continue from the end of the looped section, but instead picks up from where the sequence would be if it had not been looping.

At first I didn't like this behaviour, but now I do  :)

However, is there a way to turn this off and just have the sequencer continue from the immediate end of loop?

Thanks

Andreas

Title: Re: Sequencer Loop Behaviour
Post by: Philippe on July 18, 2012, 09:24:55 am

No there isn't. This feature was designed to keep the sequence in sync with the measure and we thought - incorrectly it seems - that no one would like the sequencer to run totally free.

Title: Re: Sequencer Loop Behaviour
Post by: ASch on July 18, 2012, 09:43:00 am

Quote from: Philippe on July 18, 2012, 09:24:55 am

No there isn't. This feature was designed to keep the sequence in sync with the measure and we thought - incorrectly it seems - that no one would like the sequencer to run totally free.

There'll always be someone Philippe  ;)

Thanks for clarifying that.

Andreas