Arturia Forums

Harware Legacy versions => Origin => Origin Technical Issues => Topic started by: Amin Bhatia on March 28, 2010, 08:53:08 pm

Title: MiniMg - Decay switch misbehaving
Post by: Amin Bhatia on March 28, 2010, 08:53:08 pm

Incosistent behaviour in decay switch on MiniMg. (The decay switch is next to the keyboard on the same page where you assign pitch bend range)

Historically turning on the decay switch should give you a release time  that is equal to the decay time that is set in the modifiers page. (ADSD)  But sometimes you'll hear no release even though decay is set to a medium amount and the decay switch is on.

Yet if you turn off and turn back on the decay switch it restores the release setting. Decay is fine it's the "release=decay" area that is misbehaving.

Might be related to a thread where going to this decay switch page sometimes locks up the Origin.

A
Version 1.1

Title: Re: MiniMg - Decay switch misbehaving
Post by: Cord on March 30, 2010, 01:05:05 am

Did you get the MiniMg template working for you, with the wheel section too?