Arturia Forums

DRUMS => Spark => Spark Technical Issues => Topic started by: ConanB on January 20, 2014, 09:31:01 pm

Title: Can't seem to turn off Reverb on Kick
Post by: ConanB on January 20, 2014, 09:31:01 pm
Hi there, I am loving my new Spark LE controller and software but I've come up against an issue that I can't figure out. I'm building a kit using different instruments from the Spark library and I can't seem to get a dry kick. I've checked the Mixer section and there is no aux 1 or 2 being sent to the reverb units. However, there is a definite reverb effect on the kick. When I go into the effects manually and turn them off I can hear the reverb stops effecting the kick but I can't see where that effect is controlled from. As I say, no aux 1 or aux 2 is being sent from the kick channel and there is no reverb effect chosen on that channel so I can't figure it out. Also cannot see the reverb return channels registering any signal when the kick is solo'd but I can hear the reverb, there's quite a lot on there. Any ideas?
Title: Re: Can't seem to turn off Reverb on Kick
Post by: ben arturia on January 22, 2014, 03:38:14 pm
I think you have an effect on your instrument not in AUX.
In the Mixer view you have an effect loaded on your track i guess.
You can edit the automation of it with the pattern view.
Check the Spark manual :
Page 48-50 and 62
http://www.arturia.net/downloads/spark/manual/SPARK_Manual_EN.pdf
Title: Re: Can't seem to turn off Reverb on Kick
Post by: Terrym on January 22, 2014, 10:56:49 pm
Hi , as ben say check your automation as this may not show on the aux on the gui, go to the sequencer and on the kick check the automation aux1/2 see if its active.

regards

Terrym