Arturia Forums
Hardware Instruments => MiniBrute => MiniBrute Technical Questions - FAQ => Topic started by: svmcwd on November 06, 2013, 04:44:27 am
-
As we all know, Arturia does a bad job at calibrating the Minibrute and also a bad job at replying to support questions (my new support tickets even seem to get deleted immidiately by now, at least I can't see any of them listed)...
So I ask the experienced users of you: how to calibrate the keyboard range of the Minibrute? Which one of the screws in the back was the correct one?
I remember roughly seeing some detailed description to it, but I can't find it anymore...
-
Check this out at 14 min's...
http://youtu.be/g7943bYSdVc
-
thanks! that's what i've been looking for :)
-
Done the calibrating now, and figured while having a really huge calibration range with multi-turn resistor, it is really hard to keep the screw at the perfect pitch point when removing the screwdriver. Am I doing something wrong or is it really that sensitive?
Right now it's ok from middle C to highest C, but off when going down to the lowest C. Did I turn the screw too far in one direction or something? Is there any trick to it?
Something is screwy about this. ;D
-
you can use this procedure. maybe not the fastest one, but it works
But indeed it's a sensitive setting.
-
Thanks! Could you make all the technotes public for anyone sorted in a single list? Some of them seem pretty essential and although it is great to get personal support here the full access to all known and relevant issues could avoid a lot of dissactifaction.
-
thanks for the feedback, I will propose the idea.
-
I created this Video Tutorial on this question, it's in french but I see a lot of video in english and I often understand the essential to know, so I hope all of you will catch the essential, so, here it is :
TUTORIEL : Accorder un oscillateur analogique (http://www.youtube.com/watch?v=evxlR5ILiEg)
:)
-
Thanks, very good explained, even for people who can't speak french! :)
PS already following you on Youtube for your previous videos about the Minibrute hehe
-
Thanks svmcwd ! Merci ! :)
-
may i wrap some piece of a plastic bag around my metal screwdriver, if i have no plastic screwdriver or does this will damage the unit?
/edit
i just carved a wooden toothpick and it worked very well ;)
-
Thanks! Could you make all the technotes public for anyone sorted in a single list? Some of them seem pretty essential and although it is great to get personal support here the full access to all known and relevant issues could avoid a lot of dissactifaction.
That'd be a great idea! I've seen TECHNOTES 1, 3, 4, & 7 being attached here on the forum, but indeed it'd be of use to have a look at the other ones as well. Would be much appreciated.
Thanks