Arturia Forums

Harware Legacy versions => KeyLab => KeyLab Users Community => Topic started by: frantzkb on September 06, 2013, 04:40:46 pm

Title: Arturia KeyLab 61 and Controllers inputs
Post by: frantzkb on September 06, 2013, 04:40:46 pm
Hello,

My first question is about the breath controller input.
What controller can I plug into the breath controller input of the Arturia KeyLab 61 keyboard ?
I am looking for a list of compatible controllers (makes and models) and could not find any information in the Keylab manual nor on Arturia's support database and forum.

The second question is about the expression pedal controller, I have read on Arturia's support knowledge base  that the Roland EV-5 should work and that we should calibrate the keyboard first.
This is here : http://www.arturia.com/evolution/kb/?View=entry&EntryID=134
and here : http://www.arturia.com/evolution/kb/?View=entry&EntryID=128

Code: [Select]
This tip applies to Analog Laboratory 49 & 61 keyboards only:
1.Power up your keyboard while simultaneously pressing the [Sound] and [Scene] buttons: the keyboard enters in calibration mode;
2.Activate the pedal for the keyboard to "see" it;
3.Rotate the [Preset] knob to first set the "Min" field;
4.Set the pedal to minimum position, then *press* the [Preset] knob to validate the shown minimum value; (NOTE: electrical value only, not MIDI, so this could vary depending on your pedal type)
5.Rotate the [Preset] knob to now set the "Max" field;
6.Set the pedal to maximum position, then *press* the [Preset] knob to validate the shown maximum value; (NOTE: electrical value only, not MIDI, so this could vary depending on your pedal type)
7.Validate the whole by *pressing* the [Category] knob: the keyboard returns in normal play mode;
8.Activate the pedal: the keyboard screen should show MIDI value "0" at minimum position, "127" at maximum.
Your keyboard is now fully serviceable.

Is it the same procédure on the new KeyLab 61 keyboard ?
I could not find anything about these controllers inputs in the manual, I downloaded here : http://www.arturia.net/downloads/keylab/manuals/keylab_EN.pdf
Why ? Is it the good manual ?

Any help will be very much appreciated.
Thank you.
Frantz.
Title: Re: Arturia KeyLab 61 and Controllers inputs
Post by: mfv on May 03, 2017, 10:50:18 am
Almost 4 years ago and no answers... That's a lousy support from you Arturia. Really low.

Do you plan to get more costumers this way?

To quote a president: "Sad".
Title: Re: Arturia KeyLab 61 and Controllers inputs
Post by: giacecco on July 13, 2020, 04:01:44 pm
Same exact issue here seven years later. Looks like we need to give up.