Arturia Forums
Hardware Instruments => MiniBrute => MiniBrute Technical Questions - FAQ => Topic started by: kaustik on June 11, 2013, 05:48:58 pm
-
Hi,
I discovered that the values the modwheel reports are jumping between two values, even when not touching the modwheel at all. To demonstrate the effect, i recorded a clip where the modwheel effects the lfo amount, and the lfo set to square modulating the pitch. It is quite obvious that the modulation depth is jumping. I already tried recalibrating the modwheel using the calibration software, but it did not help. Is that a firmware issue or some kind of hardware defect? I'm currently running the 1.0.2 beta firmware.
-
Try the calibration one more time.
I saw some guy on here who said that his didn't work right the first time, but was fixed after the second calibration attempt.
-
I already tried recalibrating it several times, but it seems like it doesn't make any difference.
I have another problem which i believe is related. When i try sending modwheel midi data to the minibrute, it will only accept the value for a very short time and jump back to the value the modwheel is set to.
-
Am I out of luck? Do I need to send my synth back into service? Any ideas?
-
Could be a loose cable inside the device, I suppose.
that could cause any number of issues.
If you file a support ticket, they'll give you instructions on how to disassemble it within warranty and check.