Arturia Forums

V Collection - Legacy versions => Analog Lab => Topic started by: vaikl on June 08, 2013, 11:13:33 pm

Title: Pads on The Laboratory not working in Chord mode
Post by: vaikl on June 08, 2013, 11:13:33 pm

AnalogLab works fine so far on a 10.7.5 i5 Mac w/ 8GB in Ableton as AU plug, I use The Laboratory and it is recognized well, incl. knobs/faders/snapshot buttons. But if I wanna use my four pads together with the chord mode in the software, I'm only hearing a single, high frequent noise with low volume, regardless which base note and chord I choose. Using my mouse on the GUI pads everything is working fine.

Bug? Feature? Or do we have to change something with the MIDI editor for The Lab??????

Title: Re: Pads on The Laboratory not working in Chord mode
Post by: vaikl on June 11, 2013, 11:02:17 pm

(bumper)

Title: Re: Pads on The Laboratory not working in Chord mode
Post by: FBGraham on June 13, 2013, 03:50:50 pm

I'm having the same problem using Akai MPK61.  Analog Lab recognizes that it has 16 pads, and gives me 16 chord pads.  The chord pads work properly when I use the mouse to click them, but I can't get them to work using the pads on the MPK61.  Please help!

Title: Re: Pads on The Laboratory not working in Chord mode
Post by: vaikl on June 13, 2013, 11:46:44 pm

After reading the fresh Analog Lab manual I'm afraid that using the pads on your controller isn't recommended to trigger chords :-X

Manual says: "...trigger chords when you click the pad". And clicking the pad means using mouse only on the plugin/standalone GUI, not using your MIDI controller. But this is one of the most mindless ideas I've seen for an instrument software... >:( >:( >:(