Arturia Forums

Hardware Instruments => MiniBrute => MiniBrute Technical Questions - FAQ => Topic started by: deadtexan on May 28, 2013, 07:14:22 am

Title: Controlling MB via Analog Four
Post by: deadtexan on May 28, 2013, 07:14:22 am

Well, have been trying to no avail to figure out what is the exact cable/splitter I will need to run this configuration. If you don't have an Analog Four, all I need for it is a standard quarter inch input. The Minibrute appears to be more confusing... I bought a quarter inch to eighth inch cable from Radioshack, then mono splitter (as that is what I had read was needed). This did not work. Then bought an adapter so that the signal would be sent in stereo. Still no luck- was only sending gate signal, no pitch control. Does anybody else here have this setup and can point me in the direction of the cable I will need?

Title: Re: Controlling MB via Analog Four
Post by: tertior on May 28, 2013, 09:17:25 am

This : http://www.woodbrass.com/cable-adaptateur-monster-cable-insert-studiolink-jack-st-2-jack-mono-3m-p28603.html more  two adatator 1/4 to 3/4.
It's difficult to find a cable   with one 1/4 stéréo to two 3/4 mono.