Arturia Forums

Hardware Instruments => MiniBrute => MiniBrute Technical Questions - FAQ => Topic started by: turntablismjunkies on May 27, 2013, 10:56:44 am

Title: cutting out
Post by: turntablismjunkies on May 27, 2013, 10:56:44 am

hi, just got my minibrute and is cutting out, all sounds stop and i have to restart it....and only have mono from the audio out, but stero from headphone. Can someone help me thanks

Title: Re: cutting out
Post by: Thunderroad75 on May 27, 2013, 03:01:33 pm

Check to see if its set to KBD on the back panel switch.

See if the arpeggiator is on.

Make sure Brute factor and Metalizer are turned right down.

Check if Mod wheel is set to LFO amt and that the LFO rate is not at its slowest speed.

All of these will cause the synth to act a little strange if you don't know what to look for.

Title: Re: cutting out
Post by: illintechnology on May 27, 2013, 05:03:55 pm

Are you controlling the MB via MIDI or CV? Disconnect those controllers and try the MB by itself.

The output of the MB is mono, there is nothing stereo about the MB.  The "stereo"  headphone jack is just two identical mono signals. Use a mono cable inthe MB main outs.

Title: Re: cutting out
Post by: turntablismjunkies on May 27, 2013, 10:31:28 pm

thanks for the help people, i will give it try...............cheers :)