Arturia Forums

Hardware Instruments => MiniBrute => MiniBrute Technical Questions - FAQ => Topic started by: zedius on February 22, 2013, 06:10:19 am

Title: Possible slider cap defect
Post by: zedius on February 22, 2013, 06:10:19 am

Each slider cap has a thin horizontal line of darker gray plastic across the middle of it. I had one of mine jettison itself today. I didn't notice until I found the piece laying on the minibrute. Luckily I did not throw it out and found where it came from! With a little careful glue, I think I'll be alright, but this was a more difficult fix than the key weights as there is very little room to fit the plastic strip into the cap's slot.

Just want to post this here as a warning to others that if you find a little piece of gray plastic on the floor, check your slider caps!!

On a related note, is there a way I can purchase spare knobs and end caps?

Thanks!

Title: Re: Possible slider cap defect
Post by: bftucker on April 18, 2013, 10:23:49 pm

I am also suddenly missing a slider cap so I am interested in get a replacement and at least a couple spares.  I am so proud of my Arturia Keyboard's appearance it hurts me to see it going without!  While I am at it, I would like to buy a couple knobs....just in case.  Thanks.

Title: Re: Possible slider cap defect
Post by: bftucker on April 19, 2013, 12:23:21 pm

Just to bump this...I need another CAP!!!

Title: Re: Possible slider cap defect
Post by: bftucker on May 05, 2013, 11:10:22 am

another bump: is there a way I can purchase spare knobs and end caps?  Doesn't anyone from Arturia have a suggestion?

Title: Re: Possible slider cap defect
Post by: Bruno@arturia on May 06, 2013, 09:21:47 am

Please PM David@Arturia, I should be able to help you on this.