Arturia Forums

Hardware Sequencers => BeatStep => BeatStep - Technical Questions - FAQ => Topic started by: Spenser Barlow on January 20, 2023, 08:44:21 pm

Title: Beatstep not saving configuration after power off
Post by: Spenser Barlow on January 20, 2023, 08:44:21 pm

Hi everyone,

Say does anyone know if my Beatstep should be saving my MCC configuration after a power off. It definitely is being saved to the device (tested by saving, restarting MCC and "Recalling From") at config creation but when unplugging it and repowering it the configs are reset.

Thanks,
Spenser

Title: Re: Beatstep not saving configuration after power off
Post by: Spenser Barlow on January 23, 2023, 05:10:56 am

In case anyone in the future has a similar problem, changes that one wishes to persist in the device configuration must be synced/stored to one of the discrete device configuration slot. The Working Memory slot is the currently restored configuration and is not mapped to the currently loaded configuration. In hindsight, this seems obvious but was not the behavior I'd been expecting.

Good luck all!

Title: Re: Beatstep not saving configuration after power off
Post by: Orn3tt3 on March 08, 2023, 10:51:33 pm

Thanks a lot!!! I was going crazy! I even took it apart cause I thought is there a battery in it that's empty  ;D ::)