Arturia Forums
Hardware Instruments => MiniFreak => MiniFreak - Technical Issues => Topic started by: samerghosn on November 17, 2022, 02:59:22 am
-
Hi,
I don't know if this is a normal behavior but when clock in is sending signal while the freak is off, when starting it the display lights and it doesn't boot. I have to turn off the signal and turn it on again.
Samer
-
Hello samerghosn.
I connected a drumbrute impact clock out to clock in of the minifreak, and tried to boot the minifreak.
I cannot reproduce the issue here, could you please give me more info:
- what is the exact setup and gear used ( synth, clock cable,
- what are the settings used ( sync settings, clock type, etc.)
- what is your Firmware version?
Thanks in advance and sorry for the inconvenience.
-
Hi Matthieu,
I am testing it with Beat Step Pro, I tried it with TRS cable and now with TS.
same behavior.
clock out BSP
clock in MnF,
MnF, it's the factory firmware version, there was no update released yet.
clock type: when i start i choose 24ppQ
thank you,
Samer
-
Clock input doesn't seem to be working for me. The manual references a section of the SYNC menu about if it starts the sequencer or not. When you go into the actual synth menu that option isn't there. I'm better there's a newer firmware that's supposed to come out. Also MIDI control center doesn't connect with it.
-
That's weird, it's working for me. I need to have sequencer option selected though.
Support told me that they fixed the problem I reported. New firmware and vst will be released tomorrow.