Arturia Forums
Hardware Instruments => PolyBrute => PolyBrute - General discussions => Topic started by: FatalRabbit on October 02, 2022, 07:09:00 pm
-
Hi,
Is it possible to have only one oscillator pick up the glide setting, and have the other oscillatopr play without glide?
-
To my experience a NP, you cannot...
- But with a small trick you can have similar: "When PolyBrute is in Split mode the glide setting is shared between the two zones. But since
Split mode assigns the A+B morphing feature to the upper zone, independent glide times
are possible: sound A glide time can be zero, and sound B glide time can be non-zero (or
vice-versa).
- Attention: works also with "Layer"
- A+B different VCOs - only possible by editing in the Morph sectionion below the Amount dial (Morph> Edit B)
- add Slide to e.g. "B"
- set Timbrality to "Layer"
Now you play A dry and B with glide
I hope this helps....
-
It does help, thank you very much for your reply! :)
-
Check ;)
..give me karma ;D