Arturia Forums
Controllers => KeyLab Essential => KeyLab Essential - General Discussions => Topic started by: Sweyn on August 23, 2022, 02:23:31 pm
-
Hello there.
I got a keylab a few months ago and set in on a keyboard tray beneath my desk. Only problem, to sit flush I had to remove all of my CC knobs. (Top right knobs, there's only knobs there but who knows)
I was wondering if anyone found arturia compatible low profile knobs I could buy or 3D print. Maybe I can sand the top of my already existing knobs ? Here's a picture of my issue : https://imgur.com/a/R8gHpNt
I could also lower the tray, but then I would lose leg space, which is already pretty tight. I can still use the CC controls without the knobs but it's pretty ghetto and looks bad.
-
I just did a search for control knobs, there are a log of knobs out there ;). I would just do some proper measurements and you should find something.