Arturia Forums

Hardware Sequencers => BeatStep => General Discussion on BeatStep => Topic started by: soundcode on June 10, 2022, 08:16:33 pm

Title: Beatstep only outputs on Channel 1
Post by: soundcode on June 10, 2022, 08:16:33 pm
I'm not able to get my beatstep to send MIDI out on anything other than channel 1. If I hold down the CHAN button I can set it to other channels, and holding it down again shows its remembered the value I set. Yet whenever I play a pad or turn the controllers they always send on channel 1. Any suggestions?
Title: Re: Beatstep only outputs on Channel 1
Post by: Tom Andrews on April 18, 2023, 02:10:01 pm
Did you ever find a solution for this? Having the same issue...
Title: Re: Beatstep only outputs on Channel 1
Post by: Mark Heath on April 18, 2023, 04:19:59 pm
sorry, was a long time ago. I did get it working in the end - I think by doing some kind of factory reset or reinstalling the drivers