Arturia Forums

Controllers => MiniLab MKII => Topic started by: mnieberg on February 13, 2022, 12:54:14 pm

Title: Knob 1 & 9 are Jumpy using the Logic Pro X Control Surface
Post by: mnieberg on February 13, 2022, 12:54:14 pm
I'm using the Minilab Mk2 with Logic 10.7.x on a M1 with the standard control surface for the Mk2. Knobs 2-8 and 10-16 are working fine but knob 1 & 9 are working not correctly. Very jumpy and wrong direction.
The Mk2 is on the 1st preset for Analog Lab and I see that the these 2 knobs have a different configuration. Relative instead of scale. But that is according to the standard preset for the Mk2.
I want to use the standard control surface because I'm using also the knobs from a Beatstep Pro to control the smart controls in Logic. And I think it is not possible to use two manually mappings for the same parameter. According to the manual it is only possible to map one parameter manually. additonal mappings are only possible via control surfaces.
Has somebody the same problem?
Title: Re: Knob 1 & 9 are Jumpy using the Logic Pro X Control Surface
Post by: Snafu23uk on April 04, 2023, 07:36:18 pm
Yes, I have this exact same problem. I can only guess that it's because these two knobs are also toggles so it's causing some sort of issue with them.