Arturia Forums
Hardware Instruments => PolyBrute => PolyBrute - Technical Issue => Topic started by: arthur_antoine on December 23, 2021, 02:01:38 pm
-
When i play an init patch, six notes in a row with a square on VCO1, the 3rd note doesnt play...!
The other waveforms work fine.
I calibrated everything several times, sometimes with success and sometimes with a timeout failure.
Downgraded the firmware to 1. But all with the same outcome, no 3rd voice being played.
So i am afraid this is a hardware issue :'(
Has anyone experienced this too?
-
Hi, I have same problem a will back the instrument to the dealer.
-
I've had contact with support during the holidays to perform some settings and enter debug mode. They were of great help and very kind. It confirmed that 1 voice was not working properIy. And I almost sent it back for repair because the problem persisted. But meanwhile i tried to get the autotuning program to finish without errors. Again and again. And after a few days of not using it, i powered it up and the tuning finished correctly and the problem disappeared! :-)
So it looked like a software issue and not a hardware problem.