Arturia Forums
Controllers => KeyLab MkII => KeyLab MkII - General Discussions => Topic started by: Lupke Brother on August 26, 2021, 07:38:45 pm
-
Hi,
My first question on this forum, so I hope my subject is posted in the right thread.
I have a Keylab 88 MKII. I have a footswitch on the aux 1 pedal and aux 2 pedal inputs. I want to use these footswitches to go up and down in my presets (analog lab V and v collection 8). The buttons and turning wheel on the keylab are fragile and not handy to switch through 10.000 presets all the time I guess :-)
1. Is this possible?
2. What settings do I need to make ( I assume in Midi control center?)
Well, many thankx if anybody knows the answer. Please let me know.
Regards,
Lupke
-
Hi,
Does'nt the arrow buttons by the Jogwheel also step through the presets? I believe so.
I don't have a Arturai controller. So i can't tell if any midi CC allready is assigned to the Next and Previous buttons to step through presets. But basicly you shall just assign the current or a free midi CC to your footswtiches - choose the correct behavior for the footswitches in MCC, and assign (midi learn) to those buttons in the V-Collection applications.
Please consult your manuals about midi learn and keep in mind that also MCC have a manual.
FYI: Alternatively you can use the Arrow buttons on your computer keyboard to step through presets.
-
Thank you LBH,
Yes, the Keylab has two buttons left and right of the jogwheel. But I think these buttons are much to fragile to go up and down through presets again and again. I know I can use the arrow keys on my computer keyboard, but that is very unsatisfying to me. I'll get a trigger finger to do this 100.000 times over and over again :-)
I'm gonna try your midi cc suggestion in MCC. Just downloaded the MCC manual too.
Off course this thread stays open for other suggestions too.
-
Hi there
I use a Boss FS-6 pedal directly connected to my Macbook. The pedal works fine in MainStage to trigger up/down presets!!