Arturia Forums
Hardware Instruments => PolyBrute => PolyBrute - General discussions => Topic started by: Lokologico on April 28, 2021, 01:55:10 am
-
Turning it on, says the VCO are cold, press ok to calibrate..
But for the life of me, I cannot find the OK button..... ???
-
me either, and if you press ok after using the polybrute connect software, the screen on the synth doesn't change. Where the F is that button???
-
I'm pretty certain the "ok" button is the 7 below the screen. At least that's what I've been using! But yes, why is this not included in the manual!!
-
from how I understand the layout, the 1 through 8 buttons below the screen act as the menu selection buttons. when there's an ambiguous selection screen like that with no number attached, I think any of the buttons 1 through 8 will work as the ok button. someone correct me if I'm wrong?
-
Pals,
Is this solved in the meantime? Pressing one of the buttons 1-8 won’t work.
Tia,
RT
-
There is one place in manual that suggests
- any of assign 1-4 work as Cancel
- any of assign 5-8 work as OK
As from calibration done only OK probably any assign button below display will work.