Arturia Forums

Software Instruments => CZ V => CZ V - Technical Issues => Topic started by: mike_mcroberts on April 22, 2021, 01:10:56 am

Title: No zero waveform selection for second oscillator
Post by: mike_mcroberts on April 22, 2021, 01:10:56 am

In a CZ-101, the first DCO has a selection of waveforms from 1-8, and the second DCO has a selection from 0-8, with zero being no choice. I don't see any choice for zero on the second DCO. Am I missing something? Or is there a way to do this? Thanks.

Title: Re: No zero waveform selection for second oscillator
Post by: LBH on April 22, 2021, 04:32:38 am

Hi,

You can draw Custom waveforms and save them as waveform presets. That should give you the options you need, if you draw lines at minimum/ zero values, if i understand you correct.

You can also switch one of the OSCs off.

Title: Re: No zero waveform selection for second oscillator
Post by: mike_mcroberts on April 22, 2021, 04:35:28 pm

I looked for a way to switch it off, but I didn't see it. How do you switch off the 2nd DCO.

Title: Re: No zero waveform selection for second oscillator
Post by: LBH on April 22, 2021, 05:42:25 pm

Left to the "Line 1" and "Line 2" text on the blue stribes above the waveforms selections you have a power icons. Click on those. You can only have one switched off at a time.

Title: Re: No zero waveform selection for second oscillator
Post by: mike_mcroberts on May 26, 2021, 10:24:35 pm

Thanks. I see the power switch for each Line. What I'm talking about is being able to switch off one of the two oscillators in each line, not the entire Line.