Arturia Forums

Controllers => MiniLab MKII => Topic started by: paolo8571 on April 13, 2021, 12:31:29 pm

Title: How to send sysex messages to rpn/nrpn encoders
Post by: paolo8571 on April 13, 2021, 12:31:29 pm

Hi eveybody,

I'm using the MiniLab for an A/V performance and I am able to send rpn/nrpn message from the controller to my pc. Now I need to reset the encoders to certain values when something happen on stage.The software is made by myself and I can send any kind of sysex message to the controller.

Is there any example that explain the correct sysex sequence to send to the minilab? it's enough a simple  example to set a certanin X encoder to a certain Y value.

Thanks a lot,

Paolo

Title: Re: How to send sysex messages to rpn/nrpn encoders
Post by: nastika on October 28, 2022, 10:53:19 pm

hey im trying to know how this "modes" do exactly. did u know each one of those what can they do, with details?

Title: Re: How to send sysex messages to rpn/nrpn encoders
Post by: paolo8571 on October 29, 2022, 12:54:37 pm

It looks that sysex messages are not supported by Arturia, I asked directly to the tecnichal support. I get some results some years ago, I was able to change colors to pads. Then nothing worked anymore, maybe due to the firmware update. I don't know if things are changed, maybe you can ask them again