Arturia Forums

Hardware Instruments => MicroFreak => MicroFreak - Technical Issues => Topic started by: Laion on April 05, 2021, 05:22:49 pm

Title: Shape knob resets to some random value in Sequencer mode
Post by: Laion on April 05, 2021, 05:22:49 pm
Hi there!

I experience a strange bug when on Sequencer mode - the "Shape" amount will reset to some value 2 seconds after I tweaked it. I don't have any modulation routed to the Shape knob, and it happens independently from the synth engine I'm using. Would you please know how to overcome this issue?

Thanks a lot!!
Best regards,
Lionel

PS: I'm on firmware 3.0
Title: Re: Shape knob resets to some random value in Sequencer mode
Post by: Amaethron on April 13, 2021, 02:40:24 pm
Are you sure that the MOD sequence isn't running? You can check that with the "Oct | Mod" button and the four LEDs besides it. And you can clear the moculation sequence by holding  "Oct | Mod" + "hold" from the sequencer (very left button)