Arturia Forums

Software Instruments => Pigments => Pigments - General Discussions => Topic started by: JBroadway on March 25, 2021, 08:32:09 pm

Title: Is it possible to route Filter 1 & 2 to independent FX busses?
Post by: JBroadway on March 25, 2021, 08:32:09 pm

I love Pigments 2 and am curious to know if it's possible to route the filters 1 and 2 into an independent FX Bus.

For example I have an Granular Engine routed to FX 1 and an Analog Engine Routed to FX 2. I'd like to apply separate FX to these engines independent of each other. I have my filter routing set to parallel and my FX routing set to parallel, but given the current UI I'm not sure if I'm missing a switch to route each filter to an it's own FX bus.

I looked through the manual too but wasn't able to find an answer
Any suggestions?

Title: Re: Is it possible to route Filter 1 & 2 to independent FX busses?
Post by: LBH on March 25, 2021, 08:55:12 pm

Hi,

It's unfortunately not possible to do things like that as it is.

There are feature requests about things like this. I don't know, if it will be implementet.

Title: Re: Is it possible to route Filter 1 & 2 to independent FX busses?
Post by: Chromat1c on April 14, 2021, 10:02:13 am

PLEASE and ability to route A - B to multi outs.