Arturia Forums

Hardware Sequencers => KeyStep 37 => KeyStep 37 - Technical Issues => Topic started by: ccook on March 14, 2021, 12:23:11 pm

Title: Stopping KS37 Transmitting Clock/Transport
Post by: ccook on March 14, 2021, 12:23:11 pm

Hi,

It might sound counter-intuitive, but is it possible to stop the KeyStep 37 from sending out clock/transport messages over midi?

The scenario is that I'm using it as a front end keyboard into an Elektron Digitakt that is the master clock/transport. I have the Digitakt set to not receive clock/transport on it's midi in, but still receive notes... the problem is I have other midi devices further down the chain that have to pick up from the Digitakt, but then also receive the commands from the KS37.

I want to just manually sync/tempo match the KS so I can use its arp/seq when I need to (mainly the arp I want), but nothing else... any ideas??

Title: Re: Stopping KS37 Transmitting Clock/Transport
Post by: Reno Vegas on March 22, 2021, 05:38:04 pm

Hi, in the MidiControlCenter "arm to Start" could help you. With this, the Keystep only starts, when you press play, even your Keystep will receive midi-clock data from extern.