Arturia Forums

Hardware Instruments => MiniBrute 2 => MiniBrute 2 - Technical Issues => Topic started by: dave the butcher on March 04, 2021, 12:43:50 pm

Title: Scratchy cutoff pot - replacement pot ?
Post by: dave the butcher on March 04, 2021, 12:43:50 pm
Hi everybody,
I have a scratchy cutoff poti and was wondering which pot was the right for replacement, i am planning to replace it myself since i'm a rather experienced diy-er. Any Ideas? Thanks in advance!
Title: Re: Scratchy cutoff pot - replacement pot ?
Post by: rynlblnc on March 22, 2021, 08:42:48 pm
I am having the same issue but i'm not a diy'er and hoping to find support from the manufacturer but not sure how to go about that
Title: Re: Scratchy cutoff pot - replacement pot ?
Post by: knerps on March 28, 2021, 03:50:51 pm
I have same cut off noise problem also osc 2 tuning is erratic and noisey
any suggestions?
Title: Re: Scratchy cutoff pot - replacement pot ?
Post by: MadHatStrider on March 29, 2021, 10:12:22 pm
I have the exact same issues.
Crackling cutoff pot
Rustling resonance and metalizer pot
and erratic and noisy osc 2 tune pot...

I am rellay frustrated by now.
I sent the unit back to arturia and they fixed everything....except that the resonance started to crackle again. Its really a pain.
I really enjoy the arturia stuff. Microbrute and Drumbrute doing their thing without any hustle till this day, but the mb 2 cause me some nervs.

Back to the topic. Maybe their is a bad production series of pots? Arturia couldnt provide me with evident infos of the problem till now.
I hope they send me  a replacement board or something like that, because i am tired of sending it back by now.