Arturia Forums

Hardware Instruments => MiniBrute 2 => MiniBrute 2 - General Discussions => Topic started by: Bappeo on January 27, 2021, 01:36:36 pm

Title: Sync the MB 2 to a Sequencer
Post by: Bappeo on January 27, 2021, 01:36:36 pm
Hi everybody.
I need some help with connecting the Minibrute 2 with KORG Electribe Sampler. I connected them with a MIDI (ES out and MB2 in) cable but doesn´t work.
I watch some videos on YT as people connect Microbrute with the ES. Is it actually possible with the MiniBrute 2? If yes how can I do it? Is there any special operation I should do with the Mini to connect it into one of the 16 Electribe channels?

Thanks in advance,

Matteo.
Title: Re: Sync the MB 2 to a Sequencer
Post by: Kevin G. on November 23, 2022, 11:35:28 am
I noticed that Korg is mentioned in a few places in the MiniBrute 2 manual.  E.g., page 78 of 131 ("p. 73"):

"7.13.1. Clock
This jack will receive a clock signal to which the tempo-based components of the MiniBrute
2 can synchronize. To use an external source as the clock, tap the large Sync button until the
LED next to the word CLK is lit.
Use the MIDI Control Center [p.109] to instruct the MiniBrute 2 what sort of external clock is
being used as the sync reference: 1step (Gate), 1step (Clock), 1pulse (Korg), 24ppq, or 48ppq."


Also see page 91 and 124 (and, of course, the MIDI Control Center software itself).