Arturia Forums

Hardware Instruments => MicroFreak => MicroFreak - Technical Issues => Topic started by: qbassa on January 14, 2021, 11:31:10 pm

Title: Firmware 3 bug with cycling envelope time
Post by: qbassa on January 14, 2021, 11:31:10 pm

When I am adjusting cycling envelope Rise/Fall shape (with shift) and release the shift and start adjusting Rise/Fall time the time value jumps to longer value of few seconds. I often use very short times in looping mode (lets say 10ms). Shape adjustment shouldn't affect Rise/Fall time that was set before adjusting shape.
I also would appreciate finer time settings in the shortest range and more precise step of 0.1ms between 0 and 10ms (it could be special mode for short cycling envelope times where whole range is 0 to 100ms for example or the maximum time is configurable - this would give amazing additional FM like modulation possibilities).

Best!
Jakub Kostynowicz 

Title: Re: Firmware 3 bug with cycling envelope time
Post by: Germain.arturia on January 15, 2021, 01:02:44 pm

HI Qbassa,
yes i can reproduce it. can't tell if this appeared with this new 3.0.6 version.
logged this into our bugtracker.
Regarding your feature request, i'll discuss it with devs.
thanks,