Arturia Forums

Hardware Instruments => MiniBrute 2S => MiniBrute 2S - Technical Issues => Topic started by: cognistudio on December 29, 2020, 04:14:41 am

Title: Sequencer not modulating voltage on Velo/Mod 1 track
Post by: cognistudio on December 29, 2020, 04:14:41 am

Hi,

Trying to use Velo track in 8V mode. I've set the Velo track to 8 steps, and I've set some voltage values for those steps. Instead of putting those voltages out on Velo output, the behaviour seems to be a bug: voltage will be constant, and it will match whatever is the last knob that was touched - even if it is knob 9-16 (knobs that shouldn't even matter, since it is an 8 step sequence). So for example, if I set all knobs 1-8 to 8V, and then touch knob 11 and set it to 2V and start the sequencer, output will be constant at 2V - simply always whatever was the value of last touched knob. Is this a known bug?

Title: Re: Sequencer not modulating voltage on Velo/Mod 1 track
Post by: cognistudio on December 29, 2020, 04:46:18 am

Oops! I had accidentally muted the track. This behaviour is normal if nothing is playing - output voltage will be the same as last knob touched.