Arturia Forums
Hardware Instruments => MicroFreak => MicroFreak - General Discussion => Topic started by: Roseweave on July 21, 2020, 10:34:56 pm
-
I heard there was a way to use the Assign knobs recursively or the like... any ideas?
-
I heard there was a way to use the Assign knobs recursively or the like... any ideas?
This is probably what you're asking about (from the user manual, page 33):
Modulating Modulation:
As mentioned before you can modulate the amount of modulation of a connection point on
the Matrix with the Sequencer modulation tracks. You assign a matrix point by holding any
assign button, then move the matrix encoder. The moment you release the assign button,
the matrix point will be set as a destination.
...