Arturia Forums

Hardware Instruments => MicroFreak => MicroFreak - Feature Requests => Topic started by: ManMantiss on July 12, 2020, 10:11:59 am

Title: Stack all 4 voices in monophonic mode
Post by: ManMantiss on July 12, 2020, 10:11:59 am
It would be sick to be able to stack all 4 voices in monophonic mode, whilst being able to control the detune spread of all 4 against each other. = FREAKIN' PHATT  :D
Title: Re: Stack all 4 voices in monophonic mode
Post by: ShapedNoise on July 14, 2020, 03:56:07 am
YES IT WOULD.
Title: Re: Stack all 4 voices in monophonic mode
Post by: DrJustice on July 15, 2020, 02:57:21 pm
+1
Title: Re: Stack all 4 voices in monophonic mode
Post by: chrisqhq on July 15, 2020, 04:00:14 pm
+1
Title: Re: Stack all 4 voices in monophonic mode
Post by: Roseweave on July 17, 2020, 04:57:20 am
Not sure there are enough knobs for this - but you could do it via Menu, though that'd be a bit unwieldy. I'm sure there's some trick, maybe with the shift knob.
Title: Re: Stack all 4 voices in monophonic mode
Post by: DrJustice on July 20, 2020, 08:40:37 pm
Shift + Paraphonic to enable unison mode.
Shift + Rate for detuning.
Optional "Utility->Preset->Unison voices : 2-4" menu entry.

Done!
Title: Re: Stack all 4 voices in monophonic mode
Post by: Roseweave on July 21, 2020, 10:35:37 pm
In that case, I would also make it so detune mode can set one as a sub-osc.
Title: Re: Stack all 4 voices in monophonic mode
Post by: SirPrimalform on September 21, 2020, 04:15:25 pm
+100!

This would normally be called unison mode and I wish it had it! It would essentially be operating in paraphonic mode but assigning the same note to all four voices. A menu setting for how many voices to use (and the possibility of octave spread) would be nice, with detune as a shift function on the panel.
Title: Re: Stack all 4 voices in monophonic mode
Post by: spritewiz on November 03, 2020, 05:07:29 am
+1