Arturia Forums

Controllers => KeyLab MkII => KeyLab MkII - General Discussions => Topic started by: andro on February 29, 2020, 09:50:47 am

Title: Three pedal set
Post by: andro on February 29, 2020, 09:50:47 am

Is it at all possible to use a three pedal piano style set such as the Roland RPU-3 with the Arturia Keylab 88 MK II, and have all the pedals work as for a piano?

Title: Re: Three pedal set
Post by: LBH on February 29, 2020, 01:42:57 pm

Hi,

As far as i can see, then that pedal has 3 wires, and if so, then Keylab MKII has the inputs. I would say it should work. But i don't have the units to test.

Title: Re: Three pedal set
Post by: HummerHealey on March 22, 2020, 12:36:11 pm

I use the rpu-3 with the Keylab 88 mk2. Works just fine..

Title: Re: Three pedal set
Post by: HummerHealey on March 25, 2020, 11:39:53 pm

Btw.... the pedals are not on/off but give an increasing signal from 0 to 127. That means for instance you can progressively the amount of an effect or modulation.

Title: Re: Three pedal set
Post by: dinobordin on November 16, 2022, 01:44:07 am

Working with arturia keylab88 mk2, moddart pianoteq and trying to connect to Roland RPU-3 pedal unit. Any suggestions please on which connection/s to use as I can only get the sustain pedal to work.
Dino

Title: Re: Three pedal set
Post by: sgbotsford on June 05, 2023, 05:36:36 pm

From my reading, you have to do come config changes.  I think the keylab can interpret the pedal signal as on/off or as continuous.  Which it does is set in config.