Arturia Forums

Hardware Instruments => MicroFreak => MicroFreak - Technical Issues => Topic started by: Spacebat_Al on February 24, 2020, 09:40:32 pm

Title: Remember last used preset after power cycle?
Post by: Spacebat_Al on February 24, 2020, 09:40:32 pm

Every time I switch micro freak off and on again, it forgets which preset I was last using and always boots up with the first preset in the list.

Is there a setting somewhere that will make Microfreak boot up with the last used preset instead?

Many thanks for any help. I checked through the manual but could not see anything.

Title: Re: Remember last used preset after power cycle?
Post by: Terrym on February 24, 2020, 10:59:38 pm

Hi , This is not a feature yet, i know its a bummer as i asked for it at the beginning of beta testing. i will ask the team how its going
and if it will get added at some point.

Title: Re: Remember last used preset after power cycle?
Post by: Spacebat_Al on February 25, 2020, 12:35:42 am

Thank you for your fast response.  In that case I will keep some post-it notes and a pen next to the synth so I can write the patch number down hehe.  :D