Arturia Forums
Hardware Instruments => MicroFreak => MicroFreak - Technical Issues => Topic started by: tompox on January 13, 2020, 09:23:44 am
-
Hey there,
Happy New Year!
My Microfreak is at the end of a MIDI chain.
Until the last firmware update, when I started the 2S which then triggered the Drumbrute, it would restart whatever Arpeggio was last played on the Microfreak. Ditto für Stop.
Now, I have to manually start the Microfreak Arpeggio which I set to the same tempo as the rest. It's quite annoying.
Where in the Hell could I get this working as before?
Thanks!
Tompox
-
Please, could someone from Arturia just acknowledge my situation?
Hey les Vertacos, bougez quoi!? ::)
-
This is a users' forum. If you want an official response you need to raise a support request through your account. Arturia staff rarely respond to questions in this forum.
-
Thanks, I finally found out that by setting local control OFF, then back on after a factory reset, all went back well.