Arturia Forums
Hardware Instruments => MicroFreak => MicroFreak - General Discussion => Topic started by: Sébastien... on December 18, 2019, 05:07:28 pm
-
Hi,
When using the micorfreak as a controller, there is a lot of different velocity going on. Even if in :
• Utility > Preset > Press mode > Aftertouch
the microfreak still send velocity as a controller.
If I try to have less variation :
• Uitlity > Misc > KBD sensitivity > 10%
I've got less variations but very, very little midi velocity (something like between 1 and 10).
I'd like the microfreak sending a fixed velocity of 100, or 127.
Now I find it very difficult to play a bass line with a regular high velocity (fingers must be flat on the board ...)
Thank you very much for your help !
-
No ideas ?
-
A little up ! :)
-
Ouaouh ...
Do you know if there is a better place to ask questions ?
-
Have you tried setting the velocity curve to Log, so that in the majority of situations the value is relatively high?
As for a better place to ask questions - raise a support ticket directly. I got a response the next working day when I asked about an issue with MIDI clock.
https://www.arturia.com/support/askforhelp (https://www.arturia.com/support/askforhelp)
-
I've noticed the same thing. It would be better if MF only sent velocity if it is selected in patch settings.Hopefully it's something that will be changed in future updates.
-
+1
Microfreak feels very cumbersome to use as a midi controller because of this.