Posted by: StudioDeutz
« on: October 03, 2022, 07:13:32 pm »Check 
..give me karma
..give me karma
February 06, 2023, 07:43:32 am
News:
Posted by: FatalRabbit
« on: October 03, 2022, 06:23:27 pm »It does help, thank you very much for your reply! 
Posted by: StudioDeutz
« on: October 03, 2022, 04:56:03 pm »To my experience a NP, you cannot...
- But with a small trick you can have similar: "When PolyBrute is in Split mode the glide setting is shared between the two zones. But since
Split mode assigns the A+B morphing feature to the upper zone, independent glide times
are possible: sound A glide time can be zero, and sound B glide time can be non-zero (or
vice-versa).
- Attention: works also with "Layer"
- A+B different VCOs - only possible by editing in the Morph sectionion below the Amount dial (Morph> Edit B)
- add Slide to e.g. "B"
- set Timbrality to "Layer"
Now you play A dry and B with glide
I hope this helps....
- But with a small trick you can have similar: "When PolyBrute is in Split mode the glide setting is shared between the two zones. But since
Split mode assigns the A+B morphing feature to the upper zone, independent glide times
are possible: sound A glide time can be zero, and sound B glide time can be non-zero (or
vice-versa).
- Attention: works also with "Layer"
- A+B different VCOs - only possible by editing in the Morph sectionion below the Amount dial (Morph> Edit B)
- add Slide to e.g. "B"
- set Timbrality to "Layer"
Now you play A dry and B with glide
I hope this helps....
Posted by: FatalRabbit
« on: October 02, 2022, 07:09:00 pm »Hi,
Is it possible to have only one oscillator pick up the glide setting, and have the other oscillatopr play without glide?
Is it possible to have only one oscillator pick up the glide setting, and have the other oscillatopr play without glide?