February 06, 2023, 11:02:14 am
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums




Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.
Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write « arturia » backwards, without uppercase:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: joeman
« on: February 06, 2020, 12:59:48 am »

Yes, very keen to have MIDI access to all params of the synth..
Posted by: DrJustice
« on: February 06, 2020, 12:21:26 am »

No, there's no such message implemented.

For an editor to learn the current state of the synth, it would need the mod matrix and sequencer data too. Perhaps we will see a full documented sysex implementation, meaning individual parameter get/set messages and individual and bulk dump of patches, that would enable 3rd party editors and librarians.
Posted by: Processaurus
« on: February 05, 2020, 11:16:10 pm »

Is there a “request all controllers” midi message received, that sends all current control values out as cc messages?

The applications are, say you start recording midi in your daw, and touch a knob- the control jumps to the knob value, and sends a cc message. You stop recording, rewind and play it again, but it sounds different... the control never went back to the original value, because the DAW never knew what that was. The request all controllers message would get the synth to spit out its controller values, if the daw asks.

It would also make 3rd party editors possible, to learn the current state of the synth. Thanks!
Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines