Pads are not keeping their states between presets...

[crony]

Hello,

I was very happy to see a firmware upgrade, so I run into it...
All seems fine, but I found one big issue : (to my opinion at least)

On a live situation, let's say I'm on preset 1, the pads are in toggle mode. I press pads 1,2,3,4, so they are red, and stays on. Cool.
Then I switch to preset 2, here my pads are in gate mode, I press pad 1, then I load again my preset 1.
I can see my pads 2,3,4, still red bright, but pad 1 is not anymore...
So it saves the state of pads "perfectly" between presets, ONLY if you don't use them while you've been loading an other preset, and pressed one of the pad that has been activated in toggle mode on the previous preset. Uncool...

Can you help please ?
Thanks

[crony]

Hmm...Tonight it's working...
So, there's no problem at all !!!

This firmware solve the problem with fast knobs, and relative midi feedback from values of virtual synths GREAT !

BUT, even if it's okay the pads there's a problem with the encoders...
Or I make a mistake with the setup, but I've tested with relative 1,2,3 , and if I change my preset, play with encoders, then back to my preset, the encoder takes the value of the latest preset...

Maybe it'll work tomorrow...Anyone can confirm ?
Thanks

[crony]

Hello ?