Keylab 49 pads velocity sensitivity, question

[jazzy]

Just got the Keylad49 yesterday and I'm still trying to sort things out.
I want to tap the pads to play a drums but found that the touch is too 'tough'.  Meaning I have to hit it real hard and I still can't get the velocity to max (127).  I fiddle with this for a few hours and the this is the best setting I came up with to get the most dynamic out of the pads, at the same time cutoff the aftertouch)
Velo after touch:  min = 0, max =1 (to get rid of the after touch)
velo curve: log#3 ( this give the most dynamic of all the curve and I can get up to 95 at the hardest hit, while 'linear' I get only velo level 0- 25)
At the force that I have to hit the pads I think I will break them shortly, so before sending this unit back, I need to know how the pads is working for everyone.
btw, I have the Midi view up to see the note and midi value received by the midi control center.

[azterix]

Just came to the forum for this same issue. I've cranked up the Min LSB to 90, but that's not a great solution... I can't get anywhere close to a reasonable range of expression. I really like that the pads aren't mushy like the m-audio units, but was expecting that the stiffer pads would give a broader range of expression, not less. Going to keep looking for a fix...

[jazzy]

Anyone else having this issue?  If there are a few more folks having this issue then it's probably is the design.  I was hoping that I have a bad unit.  Yup, by up the LSB you are now only triggering the sounds mapped to the higher velocity range.

[muzbox]

Yep, same here. Also noticed log#3 seems to be the best option...and I set the min velocity to around 60 while max at 127 for each pad. I never usually need drums at below 60-70.

[16cocopuffs]

Same thing is happening to my pads as well.  They aren't able to reach the max value at all.

[naoritzius]

Same here!
with the analog lab it works fine for me but with other vst's i got the same problem.
Arturia can you help please?

[Tausendberg]

I also have the same issue. I hope it's just firmware because I actually like these pads.

[benjaminbuckets]

has anyone found a solution for this? I'm about to sell mine if not...