program changes in vst synths like tal bas ims20 etc (not analog lab)

[monoman]

hi i have a few keylabs connected and setup sliders to work for different vsts,   i can control my (vst)synths independent
(filter freq, modulation, etc)
so all cool,
the only thing i cant figure out is to go trough a soundbank from  the synths vst using  the controller, 
i can program under some buttons a program change command with a program number,
so 5 buttons access to 5 diferent presets..
but i would like to push a button and move a slider to go trough the presets from a synthsoundbank,
(even its only one map that access the favourite sounds for that vst synth)

my icon midi keyboard for example you push program and turn a knob and i run trough all presets
from that vst.

is there a way to access the PRogram number 0-127 knob in midi control center and "connect it to
a slider or knob from the keylab ?

thanks for help,

[magnusson]

I came here to ask the same question. I'm using the TAL U-NO LX VST in Reaper and would like to be able to scroll through presets with the KeyLab, either by clicking buttons for previous and next preset, or by using one of the encoders. If anyone has any advice I'd appreciate it.

[magnusson]

I figured it out! The answer was in this video:

https://www.youtube.com/watch?v=zrLkic3NQ0g&list=UUkOvrKzWT6FW9DTSceCDoCA#t=362

Here's what you do:

* Press the "Edit" button under the screen
* Press switch 1 ("Program Change")
* Turn the "Param" encoder until "Program" is displayed on the screen
* Turn the "Value" encoder until you've selected the program number you want
* Click the "Value" encoder to load that preset

It takes a few steps initially, but if you just leave it in that mode, you can then select presets by simply turning and then clicking the "Value" encoder. I hope that helps someone!