October 26, 2016, 09:46:02 am
Welcome, Guest. Please login or register.
Did you miss your activation email
News: A maintenance is planned for Thursday, 15th of September. It should last 2 hours, starting at 10am french time.

Arturia Forums

Author Topic: Sequencer Pattern Select at Power On  (Read 631 times)


  • Apprentice
  • *
  • Posts: 9
  • Karma: 1
Sequencer Pattern Select at Power On
« on: June 07, 2014, 09:56:27 pm »
When I power on my MircoBrute and move the Sequencer Play switch to "Play," and then press a key to start the sequencer, it always plays pattern #1, regardless of which pattern is actually selected with the Pattern knob.

If I move the Pattern knob, it starts playing the correct sequence. But at power-on, the Pattern knob does not appear to be checked for its position.

MicroBrute Connect indicates that my firmware version is


  • Apprentice
  • *
  • Posts: 38
  • Karma: 2
Re: Sequencer Pattern Select at Power On
« Reply #1 on: October 05, 2014, 04:13:32 pm »
I haven't searched back to see if this is a known bug or discussed previously, but it IS a bug !
You should report it, there are far too many bugs that have been lingering around for many months now, very disappointing


Carbonate design by Bloc
SMF 2.0.11 | SMF © 2015, Simple Machines