I have my minibrute and I've noticed some issues. some functional, some cosmetic, some both. My unit has been updated to the 1.0.1 firmware.
1) My pitch wheel functions it the sense that it rolls upwards and downwards the full throw of the pot in both directions but only affects the pitch in the downwards direction, and even then only when I dime the pitch wheel does it jump to whatever value the Bend Range knob is set to. When i control it from an external midi keyboard I get it to read midi pitch bends with no problem though. It has to be an issue with either the pitch bend pot or somewhere further down the line.
2) the silkscreening of the saw/ramp on the LFO is backwards. (These things happen
When I have the lfo affecting any parameter assignable and it is in the positive section of the -/+ modulation pot the LFO goes from high to low, the opposite of what the upward running low to high ramp is showing as the silkscreened waveform. when I turn the knob to the negative half of the pot it then affects the paramentes as it should be shown on the LFO knobs waveform.
3) This has been covered already but I'd like to add my unit to the list: the Filter -/+ pot in the LFO section does NOT affect the filter cutoff when the filters cutoff knob is all the way counter clockwise. I have to rotate it almost to the noon position before the LFO filter knob has ANY affect what so ever. even then the window that is usable is shorted from the entire throw of the filter -/+ pot. This is for every waveform. Both with the Mod wheel set to "LFO amount" fully raised and not set to it.
There has to be some sort of software or resistor values not meeting in the middle as they should.
Arturia, please reply and let me know what to do about any (and hopefully) all of these issues! I'd rather not take the unit back to the store as I'm enjoying it too much minus those small issues!