Hi there, I am loving my new Spark LE controller and software but I've come up against an issue that I can't figure out. I'm building a kit using different instruments from the Spark library and I can't seem to get a dry kick. I've checked the Mixer section and there is no aux 1 or 2 being sent to the reverb units. However, there is a definite reverb effect on the kick. When I go into the effects manually and turn them off I can hear the reverb stops effecting the kick but I can't see where that effect is controlled from. As I say, no aux 1 or aux 2 is being sent from the kick channel and there is no reverb effect chosen on that channel so I can't figure it out. Also cannot see the reverb return channels registering any signal when the kick is solo'd but I can hear the reverb, there's quite a lot on there. Any ideas?