March 28, 2024, 06:02:26 pm
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: No sound! and i´m not a total noob... HELP!!  (Read 2129 times)

kaoz

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
No sound! and i´m not a total noob... HELP!!
« on: January 03, 2014, 10:55:08 am »
Hello everybody i`m new to this forum
and sadly i have to start with a tech problem.

Here the facts:

-Microbrute gives no sound out of Headphones (At the moment i can`t check out the lineout)
except directly after turned on. there would be a sound half of a second. fading away directly. this goes for sequncer and keyboard!!! SEquencer is on clock
-Envelope gets signal
- All lights are blinking busy as they did when it was working.
-filter is open wide so no this cant be it either... also envelope is set so there MUST be a signal.
-i did use the arturia power adapter and i live in germany. i did work in fact for a week.
- shortly after firmware update it went dead... but that must not be the reason.

Any suggestions? or do i have to go to the shop and give it back?

Bruno@arturia

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 501
  • Karma: 34
Re: No sound! and i´m not a total noob... HELP!!
« Reply #1 on: January 08, 2014, 10:02:14 am »
please try of setup the "basic patch" available in the user manual
Bruno
Arturia Hardware

benway

  • Apprentice
  • Apprentice
  • *
  • Posts: 25
  • Karma: 2
Re: No sound! and i´m not a total noob... HELP!!
« Reply #2 on: January 19, 2014, 07:22:33 pm »
It sounds like we are having the same problem. I went through the basic patch routine but nothing, all less working properly, envelope filter and lfo seem ok. I get just a clicking sound when I launch the sequencer. I get filter sound If I turn resonance up and cutoff down. I'm fearing the oscillator is dead. I got mine around november 11th and the problem appeared january 18th. And you?
« Last Edit: January 20, 2014, 10:56:58 am by benway »

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines