December 20, 2014, 12:40:42 pm
Welcome, Guest. Please login or register.
Did you miss your activation email
News: Arturia's webmaster is glad to offer you these brand new forums ! Have fun using it and feel free to email any encountered problem at webmaster@arturia.com.

Arturia Forums



Author Topic: Sequencing via Gate in  (Read 964 times)

slinky

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
Sequencing via Gate in
« on: December 12, 2013, 04:04:09 pm »
I have a Boss Dr-110 drum machine sending a trigger out to the gate in of my Microbrute.  Is there a way to make trigger the notes of the sequencer.  As it is it just seems to trigger the last note played on the keyboard.  I used the software to change the sequencer to gate mode, but this did not seem to work.
Thanks!

Bruno@arturia

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 687
  • Karma: 27
Re: Sequencing via Gate in
« Reply #1 on: December 13, 2013, 09:38:32 am »
you need to use Connection software. Set "Step On" option to Gate
Bruno
Arturia Hardware

jwein

  • Newbie
  • *
  • Posts: 2
  • Karma: 1
Re: Sequencing via Gate in
« Reply #2 on: January 22, 2014, 02:55:15 pm »
you need to use Connection software. Set "Step On" option to Gate

With that option on, what happens now  if the LFO-Out to the Gate-In Connector on the Backside of the Microbrute? Would it be possible to control tempo of the sequence with LFO-Rate?

ben arturia

  • Administrator
  • Hero Member
  • *****
  • Posts: 558
  • Karma: 32
Re: Sequencing via Gate in
« Reply #3 on: January 23, 2014, 04:33:03 pm »
Hi jwein,
It seems to work great.
Rate can go 99% but if you put it at max the sequencer stops.
.......testing.......

SampleHold

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
Re: Sequencing via Gate in
« Reply #4 on: March 28, 2014, 08:10:47 pm »
I set this up yesterday with my DR-55, and while it does sync, it does not sustain the sequenced note very long. Since the Gate In is in use, I cannot patch over from the Gate Out to correct. Please advise. I need the notes to be held for a very slow, droning sequence.

Can we get a firmware patch to enable longer release times globally (max release slider position = hold) like the hold switch on the back of the Mini, or is this a hardware limitation?

 

Carbonate design by Bloc
SMF 2.0.8 | SMF © 2014, Simple Machines