March 29, 2024, 08:32:19 am
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: MicroBrute Connection Software Bug  (Read 3737 times)

lentoNinos

  • Apprentice
  • Apprentice
  • *
  • Posts: 24
  • Karma: 5
MicroBrute Connection Software Bug
« on: November 22, 2013, 12:56:14 am »
I'm not sure if this is a problem with my unit, or just the firmware.
When I set the gate time in my connection software, or by sending midi CC Short gives me a long length (and half-tempo clock from midi or internal(haven't tested with gate in)), Medium and Long are exactly the same. I determined this by setting the tempo low, running a sequence and changing the gate time on the fly.
Is anyone else experiencing this?

Bruno@arturia

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 501
  • Karma: 34
Re: MicroBrute Connection Software Bug
« Reply #1 on: November 22, 2013, 09:08:40 am »
if you are using 1/32 steps, their are only 2 available Gate length, 33% and 66%, because or midi clock resolution limitation.
Do you have you bug in 1/32 or in any step size?
Bruno
Arturia Hardware

lentoNinos

  • Apprentice
  • Apprentice
  • *
  • Posts: 24
  • Karma: 5
Re: MicroBrute Connection Software Bug
« Reply #2 on: November 22, 2013, 05:47:36 pm »
Alright. I just ran through all modes.

1/4 - Short, Medium, Long are all as expected.
1/8 - Short, Medium, Long are all as expected.
1/16 - Short is short, Medium and Long are the same.
1/32 - Short is long, Medium and Long are the same (short).

Thanks for the explanation about why I only get two divisions in 1/32 step mode.  Is it also supposed to be this way for 1/16? I'm guessing yes, because that is what I'm getting. 

Bruno@arturia

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 501
  • Karma: 34
Re: MicroBrute Connection Software Bug
« Reply #3 on: November 25, 2013, 10:54:44 am »
no in 1/16th you should get 3 lengths. But in could depend on your Tempo knob position. If around max position, the detected midi clock tempo will be doubled (or divided by two at 0 setting).
It could cause the 2 lengths only behavior.

Bruno
Arturia Hardware

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines