Just wanted to know if this has been reported or if any other people have had this happen to them?
I have my MicroBrute hooked up to my DAW (Ableton) via midi and set to a specific midi channel (3 in this case) with a clip playing a bassline, but with the sequencer on the MicroBrute in 'play' mode. When starting and stopping Ableton while the sequencer on the MicrBrute is in 'play' mode it glitches quite often so the sequence starts running at a different 'rate'. I stop Ableton and the MicroBrute will then continue to play the sequence as if it has been set on 'hold' (which it hasn't). I have to turn the MicroBrute off and then switch it back on, then move the 'rate' knob to kind of reset the 'rate' parameter for it to play properly. This happens pretty regularly, enough for me to know it must be a bug of some sort.
This is a bit of a concern for me because in a live situation this would be completely catastrophic.
Anyone able to confirm this with their Micro?
I will say I do love the synth though and I hope this is just an issue that can be ironed out in a firmware release?