March 19, 2024, 03:28:29 am
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: Changing Lighted Status of Buttons via MIDI Command  (Read 1814 times)

oddacorn

  • Apprentice
  • Apprentice
  • *
  • Posts: 5
  • Karma: 0
Changing Lighted Status of Buttons via MIDI Command
« on: September 28, 2013, 04:49:14 pm »
I'm working on building a Remote configuration for using the MiniLab with Reason 7. I have the encoders working along with essentially all the other items. I'm translating pads 1-8 so they send proper note on and off messages instead of sending note on messages with 0 velocity when they're released.

Long story short, basically everything is working fine. However, I would like to use pads 9-16 as switched toggle buttons that actually reflect the state of whatever control they're connected to within the Reason Rack, and to change their lighted state if the controller is "moved" to a different device. Is it possible to send a value to the MiniLab via MIDI to change the lighted state of a pad that's set up as a switched toggle?

Thanks!

phletch

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
Re: Changing Lighted Status of Buttons via MIDI Command
« Reply #1 on: November 13, 2013, 04:20:49 pm »
I want to know this.bought it to map pads 1-16 to thor sequencer steps and want to switch over but light status doesn't change,tech support useless at this company by the look

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines